2SC482 bipolar transistor — Specifications & Equivalents

About the 2SC482

The 2SC482 is an NPN bipolar transistor with a collector–emitter voltage (V_CEO) rating of 32 V, a continuous collector current (I_C) of 0.6 A and a DC current gain (h_FE) of minimum 30. It can dissipate up to 0.6 W and is rated to a junction temperature of 175 °C. It is supplied in the TO39 package.

At a glance

• Type: NPN bipolar transistor
• Max collector–emitter voltage (V_CEO): 32 V
• Max collector current (I_C): 0.6 A
• DC current gain (h_FE): minimum 30
• Transition frequency (f_T): 50 MHz
• Power dissipation (P_D): 0.6 W
• Max junction temperature (T_J): 175 °C
• Package: TO39
• Manufacturer: Multi-source (JIS registered part number)

Typical applications

A transition frequency (f_T) of 50 MHz indicates the frequency range over which useful current gain remains available.

The quoted current gain of minimum 30 determines the base drive needed: divide your target collector current by the minimum h_FE, not the typical figure, when sizing the base resistor.

Biasing and absolute maximum ratings

Absolute-maximum breakdown limits are V_CEO 32 V, V_CBO 40 V and V_EBO 5 V (magnitudes). The emitter–base rating is the easiest to overlook and is often only a few volts, so protect the junction against reverse drive.

Dissipation is capped at 0.6 W, and that figure assumes the datasheet's mounting and ambient conditions — derate it for your own thermal design.

Choosing a replacement for the 2SC482

A drop-in substitute for the 2SC482 must be the same NPN type and offer a collector–emitter rating of at least 32 V, a collector current rating of at least 0.6 A, current gain in the same ballpark as minimum 30 and a transition frequency of at least 50 MHz for the same bandwidth.

Mechanically, check the replacement against the TO39 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Because 2SC482 is a JIS-registered part number rather than one vendor's proprietary series, it is produced by several manufacturers. Datasheet figures vary slightly between them, so check the datasheet of the brand you actually buy — this also makes like-for-like sourcing easier.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the 2SC482?

The 2SC482 is an NPN bipolar junction transistor (BJT). It is rated for 32 V collector-emitter and 0.6 A continuous collector current.

What is the maximum voltage of the 2SC482?

Maximum collector-emitter voltage (Vceo) is 32 V, and collector-base (Vcbo) is 40 V.

How much current can the 2SC482 handle?

Continuous collector current is rated at 0.6 A, with dissipation limited to 0.6 W.

What is the hFE of the 2SC482?

DC current gain (hFE) is quoted as minimum 30. Size base drive from the minimum value so the transistor saturates fully across production spread.

What package does the 2SC482 come in?

It is listed in TO39. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the 2SC482?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.