FHF5N60 MOSFET — Specifications & Equivalents

About the FHF5N60

The FHF5N60 is a MOSFET with a drain–source voltage (V_DS) rating of 600 V and a continuous drain current (I_D) of 5 A. It can dissipate up to 40 W and is rated to a junction temperature of 150 °C. It is supplied in the TO220F package.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 600 V
• Max continuous drain current (I_D): 5 A
• Power dissipation (P_D): 40 W
• Max junction temperature (T_J): 150 °C
• Package: TO220F

Typical applications

With its 600 V drain–source rating the FHF5N60 sits in the high-voltage (offline) class of switching MOSFETs, typically found in primary-side switching in offline SMPS (flyback, forward and quasi-resonant), active PFC boost stages, half-bridge and full-bridge inverters, induction heating and electronic ballasts and BLDC and AC motor drives. The rating leaves usable margin above the ~325 V DC bus obtained by rectifying 230 VAC mains, which is why this class dominates offline power supplies.

Gate drive and switching notes

Keep gate–source voltage within the ±30 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.

Choosing a replacement for the FHF5N60

A drop-in substitute for the FHF5N60 should match its polarity and offer a drain–source rating of at least 600 V and a continuous drain current rating of at least 5 A.

Mechanically, check the replacement against the TO220F footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the FHF5N60?

The FHF5N60 is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 600 V drain-source and 5 A continuous drain current.

What is the maximum voltage of the FHF5N60?

The FHF5N60 has a maximum drain-source voltage (Vds) of 600 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the FHF5N60 handle?

It is rated for 5 A of continuous drain current, with power dissipation limited to 40 W. Real-world capability depends on your heatsinking and ambient temperature.

What package does the FHF5N60 come in?

It is listed in TO220F. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the FHF5N60?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.