2P7154VC MOSFET — Specifications & Equivalents

About the 2P7154VC

The 2P7154VC is a MOSFET with a drain–source voltage (V_DS) rating of 600 V and a continuous drain current (I_D) of 75 A. It can dissipate up to 850 W and is rated to a junction temperature of 150 °C.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 600 V
• Max continuous drain current (I_D): 75 A
• Power dissipation (P_D): 850 W
• Max junction temperature (T_J): 150 °C

Typical applications

With its 600 V drain–source rating the 2P7154VC sits in the high-voltage (offline) class of switching MOSFETs, typically found in primary-side switching in offline SMPS (flyback, forward and quasi-resonant), active PFC boost stages, half-bridge and full-bridge inverters, induction heating and electronic ballasts and BLDC and AC motor drives. The rating leaves usable margin above the ~325 V DC bus obtained by rectifying 230 VAC mains, which is why this class dominates offline power supplies.

The 75 A current rating puts it in high-current territory, where conduction loss (I² × R_DS(on)) and thermal design usually matter more than switching loss. Budget for adequate copper area and a heatsink.

Gate drive and switching notes

Keep gate–source voltage within the ±25 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.

Choosing a replacement for the 2P7154VC

A drop-in substitute for the 2P7154VC should match its polarity and offer a drain–source rating of at least 600 V and a continuous drain current rating of at least 75 A.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the 2P7154VC?

The 2P7154VC is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 600 V drain-source and 75 A continuous drain current.

What is the maximum voltage of the 2P7154VC?

The 2P7154VC has a maximum drain-source voltage (Vds) of 600 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the 2P7154VC handle?

It is rated for 75 A of continuous drain current, with power dissipation limited to 850 W. Real-world capability depends on your heatsinking and ambient temperature.

What can I use to replace the 2P7154VC?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.