RFP2N20L MOSFET — Specifications & Equivalents

About the RFP2N20L

The RFP2N20L is a MOSFET with a drain–source voltage (V_DS) rating of 200 V and a continuous drain current (I_D) of 2 A. It can dissipate up to 25 W and is rated to a junction temperature of 150 °C. It is supplied in the TO220AB package.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 200 V
• Max continuous drain current (I_D): 2 A
• Power dissipation (P_D): 25 W
• Max junction temperature (T_J): 150 °C
• Package: TO220AB

Typical applications

With its 200 V drain–source rating the RFP2N20L sits in the medium-high-voltage class of switching MOSFETs, typically found in telecom and industrial DC rails, boost and flyback converters, LED and backlight drivers and power-factor-correction stages. Common where the bus sits well above 100 V but below rectified mains.

Gate drive and switching notes

Keep gate–source voltage within the ±10 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.

Switching behaviour is characterised by an output capacitance (C_oss) of 60(max) pF, which together with the gate drive determines switching loss and the practical upper frequency limit.

Choosing a replacement for the RFP2N20L

A drop-in substitute for the RFP2N20L should match its polarity and offer a drain–source rating of at least 200 V and a continuous drain current rating of at least 2 A.

Mechanically, check the replacement against the TO220AB footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the RFP2N20L?

The RFP2N20L is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 200 V drain-source and 2 A continuous drain current.

What is the maximum voltage of the RFP2N20L?

The RFP2N20L has a maximum drain-source voltage (Vds) of 200 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the RFP2N20L handle?

It is rated for 2 A of continuous drain current, with power dissipation limited to 25 W. Real-world capability depends on your heatsinking and ambient temperature.

What package does the RFP2N20L come in?

It is listed in TO220AB. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the RFP2N20L?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.