IRFP354 MOSFET — Specifications & Equivalents

About the IRFP354

The IRFP354 is a MOSFET with a drain–source voltage (V_DS) rating of 450 V and a continuous drain current (I_D) of 14 A. It can dissipate up to 190 W and is rated to a junction temperature of 150 °C. It is supplied in the TO247AC package.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 450 V
• Max continuous drain current (I_D): 14 A
• Power dissipation (P_D): 190 W
• Max junction temperature (T_J): 150 °C
• Package: TO247AC
• Manufacturer: Commonly produced by International Rectifier (now Infineon)

Typical applications

With its 450 V drain–source rating the IRFP354 sits in the medium-high-voltage class of switching MOSFETs, typically found in telecom and industrial DC rails, boost and flyback converters, LED and backlight drivers and power-factor-correction stages. Common where the bus sits well above 100 V but below rectified mains.

Gate drive and switching notes

Keep gate–source voltage within the ±20 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.

Switching behaviour is characterised by an output capacitance (C_oss) of 720 pF, which together with the gate drive determines switching loss and the practical upper frequency limit.

Choosing a replacement for the IRFP354

A drop-in substitute for the IRFP354 should match its polarity and offer a drain–source rating of at least 450 V and a continuous drain current rating of at least 14 A.

Mechanically, check the replacement against the TO247AC footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the IRFP354?

The IRFP354 is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 450 V drain-source and 14 A continuous drain current.

What is the maximum voltage of the IRFP354?

The IRFP354 has a maximum drain-source voltage (Vds) of 450 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the IRFP354 handle?

It is rated for 14 A of continuous drain current, with power dissipation limited to 190 W. Real-world capability depends on your heatsinking and ambient temperature.

What package does the IRFP354 come in?

It is listed in TO247AC. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the IRFP354?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.