STP7NK80Z MOSFET — Specifications & Equivalents

About the STP7NK80Z

The STP7NK80Z is a MOSFET with a drain–source voltage (V_DS) rating of 800 V and a continuous drain current (I_D) of 5.2 A. It can dissipate up to 125 W and is rated to a junction temperature of 150 °C. It is supplied in the TO220 package.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 800 V
• Max continuous drain current (I_D): 5.2 A
• Power dissipation (P_D): 125 W
• Max junction temperature (T_J): 150 °C
• Package: TO220
• Manufacturer: Commonly produced by STMicroelectronics

Typical applications

With its 800 V drain–source rating the STP7NK80Z sits in the high-voltage (offline) class of switching MOSFETs, typically found in primary-side switching in offline SMPS (flyback, forward and quasi-resonant), active PFC boost stages, half-bridge and full-bridge inverters, induction heating and electronic ballasts and BLDC and AC motor drives. The rating leaves usable margin above the ~325 V DC bus obtained by rectifying 230 VAC mains, which is why this class dominates offline power supplies.

Gate drive and switching notes

Keep gate–source voltage within the ±30 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.

Switching behaviour is characterised by an output capacitance (C_oss) of 122 pF, which together with the gate drive determines switching loss and the practical upper frequency limit.

Choosing a replacement for the STP7NK80Z

A drop-in substitute for the STP7NK80Z should match its polarity and offer a drain–source rating of at least 800 V and a continuous drain current rating of at least 5.2 A.

Mechanically, check the replacement against the TO220 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the STP7NK80Z?

The STP7NK80Z is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 800 V drain-source and 5.2 A continuous drain current.

What is the maximum voltage of the STP7NK80Z?

The STP7NK80Z has a maximum drain-source voltage (Vds) of 800 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the STP7NK80Z handle?

It is rated for 5.2 A of continuous drain current, with power dissipation limited to 125 W. Real-world capability depends on your heatsinking and ambient temperature.

What package does the STP7NK80Z come in?

It is listed in TO220. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the STP7NK80Z?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.