SPW47N60C3 MOSFET — Specifications & Equivalents

About the SPW47N60C3

The SPW47N60C3 is a MOSFET with a drain–source voltage (V_DS) rating of 600 V and a continuous drain current (I_D) of 47 A. It can dissipate up to 415 W and is rated to a junction temperature of 150 °C. It is supplied in the TO247 package.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 600 V
• Max continuous drain current (I_D): 47 A
• Power dissipation (P_D): 415 W
• Max junction temperature (T_J): 150 °C
• Package: TO247
• Manufacturer: Commonly produced by Infineon

Typical applications

With its 600 V drain–source rating the SPW47N60C3 sits in the high-voltage (offline) class of switching MOSFETs, typically found in primary-side switching in offline SMPS (flyback, forward and quasi-resonant), active PFC boost stages, half-bridge and full-bridge inverters, induction heating and electronic ballasts and BLDC and AC motor drives. The rating leaves usable margin above the ~325 V DC bus obtained by rectifying 230 VAC mains, which is why this class dominates offline power supplies.

Gate drive and switching notes

Keep gate–source voltage within the ±20 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.

Switching behaviour is characterised by an output capacitance (C_oss) of 2200 pF, which together with the gate drive determines switching loss and the practical upper frequency limit.

Choosing a replacement for the SPW47N60C3

A drop-in substitute for the SPW47N60C3 should match its polarity and offer a drain–source rating of at least 600 V and a continuous drain current rating of at least 47 A.

Mechanically, check the replacement against the TO247 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the SPW47N60C3?

The SPW47N60C3 is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 600 V drain-source and 47 A continuous drain current.

What is the maximum voltage of the SPW47N60C3?

The SPW47N60C3 has a maximum drain-source voltage (Vds) of 600 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the SPW47N60C3 handle?

It is rated for 47 A of continuous drain current, with power dissipation limited to 415 W. Real-world capability depends on your heatsinking and ambient temperature.

What package does the SPW47N60C3 come in?

It is listed in TO247. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the SPW47N60C3?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.