BC337-40 bipolar transistor — Specifications & Equivalents

About the BC337-40

The BC337-40 is an NPN bipolar transistor with a collector–emitter voltage (V_CEO) rating of 45 V, a continuous collector current (I_C) of 0.8 A and a DC current gain (h_FE) of minimum 250. It can dissipate up to 0.36 W and is rated to a junction temperature of 150 °C. It is supplied in the TO92 package.

At a glance

• Type: NPN bipolar transistor
• Max collector–emitter voltage (V_CEO): 45 V
• Max collector current (I_C): 0.8 A
• DC current gain (h_FE): minimum 250
• Transition frequency (f_T): 60 MHz
• Power dissipation (P_D): 0.36 W
• Max junction temperature (T_J): 150 °C
• Package: TO92
• Manufacturer: Multi-source (Pro Electron registered part number)

Typical applications

A transition frequency (f_T) of 60 MHz indicates the frequency range over which useful current gain remains available.

The quoted current gain of minimum 250 determines the base drive needed: divide your target collector current by the minimum h_FE, not the typical figure, when sizing the base resistor.

Biasing and absolute maximum ratings

Absolute-maximum breakdown limits are V_CEO 45 V, V_CBO 50 V and V_EBO 5 V (magnitudes). The emitter–base rating is the easiest to overlook and is often only a few volts, so protect the junction against reverse drive.

Dissipation is capped at 0.36 W, and that figure assumes the datasheet's mounting and ambient conditions — derate it for your own thermal design.

Choosing a replacement for the BC337-40

A drop-in substitute for the BC337-40 must be the same NPN type and offer a collector–emitter rating of at least 45 V, a collector current rating of at least 0.8 A, current gain in the same ballpark as minimum 250 and a transition frequency of at least 60 MHz for the same bandwidth.

Mechanically, check the replacement against the TO92 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Because BC337-40 is a Pro Electron-registered part number rather than one vendor's proprietary series, it is produced by several manufacturers. Datasheet figures vary slightly between them, so check the datasheet of the brand you actually buy — this also makes like-for-like sourcing easier.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the BC337-40?

The BC337-40 is an NPN bipolar junction transistor (BJT). It is rated for 45 V collector-emitter and 0.8 A continuous collector current.

What is the maximum voltage of the BC337-40?

Maximum collector-emitter voltage (Vceo) is 45 V, and collector-base (Vcbo) is 50 V.

How much current can the BC337-40 handle?

Continuous collector current is rated at 0.8 A, with dissipation limited to 0.36 W.

What is the hFE of the BC337-40?

DC current gain (hFE) is quoted as minimum 250. Size base drive from the minimum value so the transistor saturates fully across production spread.

What package does the BC337-40 come in?

It is listed in TO92. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the BC337-40?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.