2N7002PS MOSFET — Specifications & Equivalents

About the 2N7002PS

The 2N7002PS is a MOSFET with a drain–source voltage (V_DS) rating of 60 V and a continuous drain current (I_D) of 0.32 A. It can dissipate up to 0.28 W. It is supplied in the TSSOP6 package.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 60 V
• Max continuous drain current (I_D): 0.32 A
• Power dissipation (P_D): 0.28 W
• Package: TSSOP6
• Manufacturer: Multi-source (JEDEC registered part number)

Typical applications

With its 60 V drain–source rating the 2N7002PS sits in the mid-range class of switching MOSFETs, typically found in 24 V and 48 V industrial and battery systems, motor drives and H-bridges and load and hot-swap switching.

At 0.32 A it is aimed at small-signal and light-load switching rather than power conversion.

Choosing a replacement for the 2N7002PS

A drop-in substitute for the 2N7002PS should match its polarity and offer a drain–source rating of at least 60 V and a continuous drain current rating of at least 0.32 A.

Mechanically, check the replacement against the TSSOP6 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Because 2N7002PS is a JEDEC-registered part number rather than one vendor's proprietary series, it is produced by several manufacturers. Datasheet figures vary slightly between them, so check the datasheet of the brand you actually buy — this also makes like-for-like sourcing easier.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the 2N7002PS?

The 2N7002PS is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 60 V drain-source and 0.32 A continuous drain current.

What is the maximum voltage of the 2N7002PS?

The 2N7002PS has a maximum drain-source voltage (Vds) of 60 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the 2N7002PS handle?

It is rated for 0.32 A of continuous drain current, with power dissipation limited to 0.28 W. Real-world capability depends on your heatsinking and ambient temperature.

What package does the 2N7002PS come in?

It is listed in TSSOP6. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the 2N7002PS?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.