2N3905CSM bipolar transistor — Specifications & Equivalents

About the 2N3905CSM

The 2N3905CSM is a PNP bipolar transistor with a collector–emitter voltage (V_CEO) rating of 25 V, a continuous collector current (I_C) of 0.2 A and a DC current gain (h_FE) of minimum 100. It can dissipate up to 0.31 W and is rated to a junction temperature of 135 °C. It is supplied in the LCC3 package.

At a glance

• Type: PNP bipolar transistor
• Max collector–emitter voltage (V_CEO): 25 V
• Max collector current (I_C): 0.2 A
• DC current gain (h_FE): minimum 100
• Transition frequency (f_T): 200 MHz
• Power dissipation (P_D): 0.31 W
• Max junction temperature (T_J): 135 °C
• Package: LCC3
• Manufacturer: Multi-source (JEDEC registered part number)

Typical applications

Judging from its ratings the 2N3905CSM is generally applied in RF and high-speed switching stages and small-signal amplification and general-purpose switching.

A transition frequency (f_T) of 200 MHz indicates the frequency range over which useful current gain remains available.

The quoted current gain of minimum 100 determines the base drive needed: divide your target collector current by the minimum h_FE, not the typical figure, when sizing the base resistor.

Biasing and absolute maximum ratings

Absolute-maximum breakdown limits are V_CEO 25 V, V_CBO 40 V and V_EBO 5 V (magnitudes). The emitter–base rating is the easiest to overlook and is often only a few volts, so protect the junction against reverse drive.

Dissipation is capped at 0.31 W, and that figure assumes the datasheet's mounting and ambient conditions — derate it for your own thermal design.

Choosing a replacement for the 2N3905CSM

A drop-in substitute for the 2N3905CSM must be the same PNP type and offer a collector–emitter rating of at least 25 V, a collector current rating of at least 0.2 A, current gain in the same ballpark as minimum 100 and a transition frequency of at least 200 MHz for the same bandwidth.

Mechanically, check the replacement against the LCC3 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Because 2N3905CSM is a JEDEC-registered part number rather than one vendor's proprietary series, it is produced by several manufacturers. Datasheet figures vary slightly between them, so check the datasheet of the brand you actually buy — this also makes like-for-like sourcing easier.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the 2N3905CSM?

The 2N3905CSM is a PNP bipolar junction transistor (BJT). It is rated for 25 V collector-emitter and 0.2 A continuous collector current.

What is the maximum voltage of the 2N3905CSM?

Maximum collector-emitter voltage (Vceo) is 25 V, and collector-base (Vcbo) is 40 V.

How much current can the 2N3905CSM handle?

Continuous collector current is rated at 0.2 A, with dissipation limited to 0.31 W.

What is the hFE of the 2N3905CSM?

DC current gain (hFE) is quoted as minimum 100. Size base drive from the minimum value so the transistor saturates fully across production spread.

What package does the 2N3905CSM come in?

It is listed in LCC3. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the 2N3905CSM?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.