G8N80BF MOSFET — Specifications & Equivalents

About the G8N80BF

The G8N80BF is a MOSFET with a drain–source voltage (V_DS) rating of 800 V and a continuous drain current (I_D) of 8 A. It can dissipate up to 45 W and is rated to a junction temperature of 150 °C. It is supplied in the TO220F package.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 800 V
• Max continuous drain current (I_D): 8 A
• Power dissipation (P_D): 45 W
• Max junction temperature (T_J): 150 °C
• Package: TO220F

Typical applications

With its 800 V drain–source rating the G8N80BF sits in the high-voltage (offline) class of switching MOSFETs, typically found in primary-side switching in offline SMPS (flyback, forward and quasi-resonant), active PFC boost stages, half-bridge and full-bridge inverters, induction heating and electronic ballasts and BLDC and AC motor drives. The rating leaves usable margin above the ~325 V DC bus obtained by rectifying 230 VAC mains, which is why this class dominates offline power supplies.

Gate drive and switching notes

Keep gate–source voltage within the ±30 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.

Switching behaviour is characterised by an output capacitance (C_oss) of 150 pF, which together with the gate drive determines switching loss and the practical upper frequency limit.

Choosing a replacement for the G8N80BF

A drop-in substitute for the G8N80BF should match its polarity and offer a drain–source rating of at least 800 V and a continuous drain current rating of at least 8 A.

Mechanically, check the replacement against the TO220F footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the G8N80BF?

The G8N80BF is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 800 V drain-source and 8 A continuous drain current.

What is the maximum voltage of the G8N80BF?

The G8N80BF has a maximum drain-source voltage (Vds) of 800 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the G8N80BF handle?

It is rated for 8 A of continuous drain current, with power dissipation limited to 45 W. Real-world capability depends on your heatsinking and ambient temperature.

What package does the G8N80BF come in?

It is listed in TO220F. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the G8N80BF?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.