FA38SA50LCP MOSFET — Specifications & Equivalents
About the FA38SA50LCP
The FA38SA50LCP is an N-channel MOSFET with a drain–source voltage (VDS) rating of 500 V, a continuous drain current (ID) of 38 A and an on-resistance (RDS(on)) of 0.13 Ω. It can dissipate up to 500 W and is rated to a junction temperature of 150 °C. It is supplied in the SOT-227 package.
At a glance
- Type: N-channel MOSFET
- Max drain–source voltage (VDS): 500 V
- Max continuous drain current (ID): 38 A
- On-resistance (RDS(on)): 0.13 Ω
- Power dissipation (PD): 500 W
- Max junction temperature (TJ): 150 °C
- Package: SOT-227
Typical applications
With its 500 V drain–source rating the FA38SA50LCP sits in the high-voltage (offline) class of switching MOSFETs, typically found in primary-side switching in offline SMPS (flyback, forward and quasi-resonant), active PFC boost stages, half-bridge and full-bridge inverters, induction heating and electronic ballasts and BLDC and AC motor drives. The rating leaves usable margin above the ~325 V DC bus obtained by rectifying 230 VAC mains, which is why this class dominates offline power supplies.
Gate drive and switching notes
Keep gate–source voltage within the ±20 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.
Switching behaviour is characterised by a rise time of 340 ns and an output capacitance (Coss) of 1600 pF, which together with the gate drive determines switching loss and the practical upper frequency limit.
Choosing a replacement for the FA38SA50LCP
A drop-in substitute for the FA38SA50LCP must be the same N-channel type and offer a drain–source rating of at least 500 V, a continuous drain current rating of at least 38 A and an on-resistance no higher than 0.13 Ω if efficiency and heat matter.
Mechanically, check the replacement against the SOT-227 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.
Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.
Frequently asked questions
What is the FA38SA50LCP?
The FA38SA50LCP is an N-channel MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 500 V drain-source and 38 A continuous drain current.
What is the maximum voltage of the FA38SA50LCP?
The FA38SA50LCP has a maximum drain-source voltage (Vds) of 500 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.
How much current can the FA38SA50LCP handle?
It is rated for 38 A of continuous drain current, with power dissipation limited to 500 W. Real-world capability depends on your heatsinking and ambient temperature.
What is the on-resistance of the FA38SA50LCP?
On-resistance (Rds(on)) is 0.13 Ω. Multiply by the square of your load current to estimate conduction loss.
What package does the FA38SA50LCP come in?
It is listed in SOT-227. Verify the pinout of the specific variant, as one outline can carry different pin assignments.
What can I use to replace the FA38SA50LCP?
No verified equivalents are listed yet. Choose a part of the same polarity that meets or exceeds every rating above and shares a compatible package and pinout.
Key Specifications
| Type | MOSFET |
|---|---|
| Channel Type | N -Channel |
| Drain-Source Voltage (Vds) | 500 V |
| Gate-Source Voltage (Vgs) | 20 V |
| Drain Current (Id) | 38 A |
| Drain-Source On-Resistance (Rds) | 0.13 |
| Rise Time (tr) | 340 nS |
| Output Capacitance (Coss) | 1600 pF |
| Junction Temperature (Tj) | 150 °C |
| Package | SOT-227 |
| Power Dissipation (Pd) | 500 W |
Equivalent & Replacement Parts
No verified equivalents are listed for FA38SA50LCP yet.