2SK979 MOSFET — Specifications & Equivalents
Manufacturer: Multi-source (JIS registered part number)
About the 2SK979
The 2SK979 is an N-channel MOSFET with a drain–source voltage (VDS) rating of 450 V, a continuous drain current (ID) of 10 A and an on-resistance (RDS(on)) of 0.7 Ω. It can dissipate up to 120 W and is rated to a junction temperature of 150 °C. It is supplied in the TO247 package.
At a glance
- Type: N-channel MOSFET
- Max drain–source voltage (VDS): 450 V
- Max continuous drain current (ID): 10 A
- On-resistance (RDS(on)): 0.7 Ω
- Power dissipation (PD): 120 W
- Max junction temperature (TJ): 150 °C
- Package: TO247
- Manufacturer: Multi-source (JIS registered part number)
Typical applications
With its 450 V drain–source rating the 2SK979 sits in the medium-high-voltage class of switching MOSFETs, typically found in telecom and industrial DC rails, boost and flyback converters, LED and backlight drivers and power-factor-correction stages. Common where the bus sits well above 100 V but below rectified mains.
Gate drive and switching notes
Keep gate–source voltage within the ±20 V maximum; exceeding it punctures the gate oxide and destroys the device permanently.
Choosing a replacement for the 2SK979
A drop-in substitute for the 2SK979 must be the same N-channel type and offer a drain–source rating of at least 450 V, a continuous drain current rating of at least 10 A and an on-resistance no higher than 0.7 Ω if efficiency and heat matter.
Mechanically, check the replacement against the TO247 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.
Because 2SK979 is a JIS-registered part number rather than one vendor's proprietary series, it is produced by several manufacturers. Datasheet figures vary slightly between them, so check the datasheet of the brand you actually buy — this also makes like-for-like sourcing easier.
Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.
Frequently asked questions
What is the 2SK979?
The 2SK979 is an N-channel MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 450 V drain-source and 10 A continuous drain current.
What is the maximum voltage of the 2SK979?
The 2SK979 has a maximum drain-source voltage (Vds) of 450 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.
How much current can the 2SK979 handle?
It is rated for 10 A of continuous drain current, with power dissipation limited to 120 W. Real-world capability depends on your heatsinking and ambient temperature.
What is the on-resistance of the 2SK979?
On-resistance (Rds(on)) is 0.7 Ω. Multiply by the square of your load current to estimate conduction loss.
What package does the 2SK979 come in?
It is listed in TO247. Verify the pinout of the specific variant, as one outline can carry different pin assignments.
What can I use to replace the 2SK979?
No verified equivalents are listed yet. Choose a part of the same polarity that meets or exceeds every rating above and shares a compatible package and pinout.
Key Specifications
| Type | MOSFET |
|---|---|
| Channel Type | N -Channel |
| Drain-Source Voltage (Vds) | 450 V |
| Gate-Source Voltage (Vgs) | 20 V |
| Drain Current (Id) | 10 A |
| Drain-Source On-Resistance (Rds) | 0.7 |
| Junction Temperature (Tj) | 150 °C |
| Package | TO247 |
| Power Dissipation (Pd) | 120 W |
Equivalent & Replacement Parts
No verified equivalents are listed for 2SK979 yet.