2N7103 MOSFET — Specifications & Equivalents

About the 2N7103

The 2N7103 is a MOSFET with a drain–source voltage (V_DS) rating of 650 V and a continuous drain current (I_D) of 14 A. It can dissipate up to 150 W and is rated to a junction temperature of 150 °C. It is supplied in the TO210 package.

At a glance

• Type: MOSFET
• Max drain–source voltage (V_DS): 650 V
• Max continuous drain current (I_D): 14 A
• Power dissipation (P_D): 150 W
• Max junction temperature (T_J): 150 °C
• Package: TO210
• Manufacturer: Multi-source (JEDEC registered part number)

Typical applications

With its 650 V drain–source rating the 2N7103 sits in the high-voltage (offline) class of switching MOSFETs, typically found in primary-side switching in offline SMPS (flyback, forward and quasi-resonant), active PFC boost stages, half-bridge and full-bridge inverters, induction heating and electronic ballasts and BLDC and AC motor drives. The rating leaves usable margin above the ~325 V DC bus obtained by rectifying 230 VAC mains, which is why this class dominates offline power supplies.

Choosing a replacement for the 2N7103

A drop-in substitute for the 2N7103 should match its polarity and offer a drain–source rating of at least 650 V and a continuous drain current rating of at least 14 A.

Mechanically, check the replacement against the TO210 footprint and confirm the pin order — parts sharing a package outline do not always share a pinout.

Because 2N7103 is a JEDEC-registered part number rather than one vendor's proprietary series, it is produced by several manufacturers. Datasheet figures vary slightly between them, so check the datasheet of the brand you actually buy — this also makes like-for-like sourcing easier.

Where the application switches inductive loads or runs near the voltage limit, keep extra headroom rather than choosing a part that only just meets the original numbers.

Frequently asked questions

What is the 2N7103?

The 2N7103 is a MOSFET (metal-oxide-semiconductor field-effect transistor). It is rated for 650 V drain-source and 14 A continuous drain current.

What is the maximum voltage of the 2N7103?

The 2N7103 has a maximum drain-source voltage (Vds) of 650 V. Treat this as an absolute maximum and design with margin, especially when switching inductive loads.

How much current can the 2N7103 handle?

It is rated for 14 A of continuous drain current, with power dissipation limited to 150 W. Real-world capability depends on your heatsinking and ambient temperature.

What package does the 2N7103 come in?

It is listed in TO210. Verify the pinout of the specific variant, as one outline can carry different pin assignments.

What can I use to replace the 2N7103?

This page lists 17 candidate equivalents matched on electrical ratings and package. Any replacement should meet or exceed the original voltage, current and dissipation figures and use a compatible drive level.